4.3 System Programming
VM Status DTMF Set
System Programming 4-45
113
Description Sets the DTMF signals transmitted to your Voice Processing
System (VPS) to inform the VPS of the VPS ports states quickly:
The following signals are sent to the VPS with the assigned DTMF
signals:
RBT (ringback tone) : This signal is sent when calling an
extension.
BT (busy tone) : This is sent when the called extension is
busy.
ROT (reorder tone) : This is sent when the dialed number is
invalid.
DND (DND tone) : This is sent when the other extension has
DND assigned.
Answer : This is sent when the other extension
answers the call.
Disconnect : This is sent when the other extension
hangs up.
Confirm (confirmation tone) :
This is sent when the feature number for
“Message Waiting Lamp” is valid.
FWD VM RBT (FWD to VM ringback tone) :
Not available (reserved).
FWD VM BT (FWD to VM busy tone) :
This is sent when the called extension
has set Call Forwarding to VPS.
FWD EXT RBT (FWD to extension ringback tone) :
Not available (reserved).
Selection • RBT / BT / ROT / DND / Answer / Disconnect / Confirm /
FWD VM RBT / FWD VM BT / FWD EXT RBT
• DTMF signal number: 3 digits (max.)
Default RBT – 1; BT – 2; ROT – 3; DND – 4; Answer – 5; Disconnect – #9
Confirm – 9; FWD VM RBT – 6; FWD VM BT – 7; FWD EXT
RBT – 8
Programming 1. Enter 113.
Display: VM Status Set
2. Press NEXT to program ringback tone status.
To program another status, keep pressing NEXT until the desired
status is displayed.
Display example: RBT :1
To Next Page
Loading...
