4.6 CO Line Programming
CPC Signal Detection Outgoing Set
System Programming 4-95
415
Description Enables or disables CPC Signal Detection during the time between
the originated outside call and the established outside call. If this is
enabled, the system disconnects the line with the time set in
program [405] “CPC Signal Detection Incoming Set” when CPC
Signal is detected.
Selection • CO line number:
KX-TD816 – 01 through 08, ( =all CO lines)
KX-TD1232 – 01 through 24, ( =all CO lines)
• Enable (detection) / Disable (no detection)
Default Disable
Programming 1. Enter 415.
Display: CPC Outgoing Asn
2. Press NEXT.
Display: CO Line NO?→
3. Enter a CO line number.
To enter CO line number 01, you can also press NEXT.
Display example: CO01:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Some central offices (CO) may send CPC-like signals during the dialing
sequence and an attempt to make a call may be terminated. If your CO
is such a type, select “Disable.”
• CPC Signal Detection is effective only with the 4-DID Line Unit (KX-
TD185) (KX-TD816: CO05 through CO08, KX-TD1232: CO09
through CO12 – Master / CO21 through CO24 – Slave). In this case,
“D (4DID)” must be selected in program [109] “Expansion Card / Unit
Type.”
To Next Page
Loading...
Need help?
General
