3 Features R
Features 3-97
Conditions • This feature works only on CO lines set to Pulse Dialing mode or Call
Blocking mode.
• Dial Type Selection provides selection of a dial mode for each CO line.
• Changing tone to pulse is not possible.
Programming References
Section 4, System Programming,
[402] Dial Mode Selection
Feature References Section 3, Features,
Dial Type Selection
Operation References DPT Features, SLT Features;
—User Manual Pulse to Tone Conversion
Recall
Description The RECALL button is used to allow a digital proprietary
telephone user to disconnect from the current call and originate
another call without hanging up first.
Conditions • By default setting, pressing RECALL button with a digital proprietary
telephone works as External Feature Access. By changing the
programmed data, it works as Recall (disconnection).
• Pressing the RECALL button re-starts the conversation duration,
outputs an SMDR record, inserts the automatic pause, and checks toll
restriction level again.
• It is required to enable this function at the locked extension and toll-
restricted extension by system programming.
Programming References
Section 4, System Programming,
[414] Disconnect Time
[990] System Additional Information, Fields (3), (15)
Feature References Section 3, Features,
External Feature Access
Operation References DPT Features,
—User Manual Recall
To Next Page
Loading...
