4.3 System Programming
Charge Verification Assignment
118
4-52 System Programming
Description Assigns the extension which is allowed to refer or clear for the call
information on the extension, CO line, account code, and the total.
Selection • Jack number: KX-TD816 – 01 through 16, ( =all jacks)
KX-TD1232 – 01 through 64, ( =all jacks)
• Enable / Disable
Default All jacks – Enable
Programming 1. Enter 118.
Display:Charge Refer Ext
2. Press NEXT.
Display:Jack NO?–>
3. Enter a jack number.
To enter jack number 01, you can also press NEXT.
Display example: #01:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or
SELECT and the desired jack number.
7. Press END.
Conditions • In the case of KX-TD1232, jack numbers 01 through 32 are for the
Master System and 33 through 64 are for the slave.
• To assign all jack numbers to one selection, press the key at step 3.
In this case, the display shows the contents programmed for Jack 01.
Feature Reference Section 3, Features,
Charge Fee Reference
To Next Page
Loading...
