4.3 System Programming
Day / Night Service Switching Mode
101
4-36 System Programming
Description This program is used to determine if night mode is automatic or
manual.
Selection Manual / Auto (automatic)
Default Manual
Programming 1. Enter 101.
Display: Day/Night Mode
2. Press NEXT.
Display example: D/N Mode:Manual
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Conditions • If automatic switching is assigned, day / night mode is switched at the
time programmed in [102] “Day / Night Service Starting Time.”
• The operator can switch the day / night mode at any time.
Feature References Section 3, Features,
Night Service
To Next Page
Loading...
