4.3 System Programming
Expansion Card / Unit Type
(contd.)
109
4-44 System Programming
7. Press STORE.
If only one system is in operation, go to step 8.
8. Press NEXT to program Slave System.
Display example: Slave :C;C;E1;E2
9. Repeat steps 3 and 7.
10. Press END.
Conditions • In case of starting the system for the first time or System Data Clear, the
application for location will adapt the practical installation instead of
system default setting.
• There are two expansion areas in KX-TD816, areas 1 and 2 from
bottom to top.
• For KX-TD1232, there is one expansion area inside the system, area 1,
and there are three expansion area on the system, area 2, 3 and 4 from
bottom to top.
• If the Slave System of KX-TD1232 is out-of-service, skip the steps 8
and 9.
• After changing the setting, to make your setting effective, unplug the
system once and plug it in again. Otherwise the previous setting will be
maintained.
Feature References Section 3, Features,
Module Expansion
To Next Page
Loading...
