4.6 CO Line Programming
Host PBX Access Codes (contd.)
System Programming 4-91
411
Conditions • This program is only required if a host PBX line is connected to the
system. Program [401] “CO Line Group Assignment” is used to assign
the line to a CO line group.
• There is a maximum of four access codes per CO line group. Each
code has one or two digits, consisting of 0 through 9, and .
• If conflicting access codes (such as 8 and 81) are stored for the same
CO line group, the 1-digit code (8) only will be in effect.
• When the programmed codes are dialed, Automatic Pause Insertion and
Toll Restriction are applied to the calls. The programmed pause time
(in program [412] “Pause Time”) is automatically inserted after the
access code.
• To assign all CO line groups to one selection, press the key at step 3.
In this case, the display shows the contents programmed for CO line
group 1.
Feature References Section 3, Features,
External Feature Access Pause Insertion, Automatic
Host PBX Access
To Next Page
Loading...
