3 Features A
Features 3-3
unless it has previously been stored in memory:
• Call Forwarding – to CO Line
• Last Number Redial
• Line Access
• One-Touch Dialing
• Pickup Dialing
• Saved Number Redial
• Station Speed Dialing
• System Speed Dialing
In Verified-Toll Restriction Override mode, the user can enter a
pre-assigned account code only when the user needs to override
toll restriction.
In Option mode, the user can enter any account code if needed.
Conditions • An account code can be stored into Memory Dialing (System / Station
Speed Dialing; One-Touch Dialing; Pickup Dialing; Call Forwarding –
to CO Line).
• The Account button may be used in place of the feature number. A
flexible button on the proprietary telephone set can be programmed as
the Account button.
• Account code entry after CPC detection must be done within 15
seconds. Otherwise, SMDR call record is activated and entry becomes
impossible afterwards.
• If disconnection signal is selected in program [990], field (3) and
Recall function is enabled in field (15), the Verified
-All Calls extension
is allowed to make an outside call using the same line with Recall
function.
• If an account code is appended to a call, specified display telephone
users can see the charge for the call (Charge Fee Reference).
• In any mode, emergency dial numbers stored in program [311]
Emergency Dial Set can be dialed out without an account code entry.
Programming References
Section 4, System Programming,
[005] Flexible CO Button Assignment
[100] Flexible Numbering, Account code entry
[508] Account Code Entry Mode
[990] System Additional Information, Fields (3), (15)
Station Programming.......................................................User Manual,
Charge Fee Reference
Flexible Button Assignment – Account Button
Feature References Section 3, Features,
Charge Fee Reference
Toll Restriction Override by Account Code Entry
To Next Page
Loading...
