590 Series DC Digital Drive Programming D-1
Appendix D Programming
This Appendix provides an introduction to programming the drive. It describes the function blocks and
parameters available in DSElite. The FUNCTION BLOCKS menu on the MMI provides access to these
programming tool menu structures.
Programming Your Appl
ication............................ D-3
Programming with Block Diagrams D-3
Modifying a Block Diagram D-3
Saving Your Modifications D-6
Understanding the Function Block Description D-6
MMI Menu Maps D-7
Function Blocks By Category D-8
Compatibility with Earlier Versions of Firmware D-9
Function Block Descriptions ............................... D-12
5703 IN D-12
5703 OUT D-13
ADVANCED D-14
ALARM HISTORY D-17
ALARMS D-18
ANALOG INPUTS D-23
ANALOG OUTPUTS D-25
AUTOTUNE D-26
AUX I/O D-28
CALIBRATION D-29
CONFIGURE DRIVE D-32
CURRENT LOOP D-33
CURRENT PROFILE D-38
DEADBAND D-39
DEMULTIPLEXER D-40
DIAMETER CALC. D-41
DIGITAL INPUTS D-49
DIGITAL OUTPUTS D-52
DRIVE INFO D-55
ENCODER D-56
Functional Description D-57
FEEDBACKS D-58
FIELD CONTROL D-59
INERTIA COMP D-66
LINK D-67
INVERSE TIME D-68
JOG/SLACK D-69
To Next Page
Loading...
