Parker 591C - Main Port (P1

D-72 Programming 590 Series DC Digital Drive
MAIN PORT (P1)
Use this block to configure the drive's P1 port.
Refer to Appendix A: “Serial Communications” – Main Port P1 for further information.
This function block configures the drive to use the plug-in communication Option Board.
The P1 port is a non-isolated serial communications port built in to the drive's Control Board.
It is used off-line (while the drive is stopped) for transferring and saving drive configuration
files using a personal computer (PC) running a serial communications program, or on-line
(while the drive is running) when using the Parker SSD Drives 5703 Setpoint Repeater Unit.
You can also use the P1 port to transfer configuration files by connecting to a PC running the
Windows
TM
compatible software package "DSE Lite". Refer to the DSE manual
HA471486U001.
MAIN PORT (P1)
Parameter Tag Range
MODE 148
See below
Used the set the protocol on this port.
0 : DISABLED
1 : 5703 MASTER
2 : 5703 SLAVE
3 : EIASCII
4 : EIBINARY
BAUD RATE 150
See below
Transmission rate. Options available are:
0 : 300
1 : 600
2 : 1200
3 : 2400
4 : 4800
5 : 9600 (default)
6 : 19200
7 : 38400 (reserved for future use)
8 : 57600 (reserved for future use)
9 : 115200 (reserved for future use)
GROUP ID (GID) 138
0 to 7
The Parker SSD Drives protocol group identity address.