Parker 591C - Calibration

D-30 Programming 590 Series DC Digital Drive
CALIBRATION
Parameter Tag Range
FIELD I CAL. 182 0.9800 to 1.1000
Trim adjustment of the motor field current to give exactly 100% at the required actual current value (e.g. 1.5A etc.).
Note:- Primary field calibration is achieved by adjusting SW4 – 6.
TERMINAL VOLTS 57
⎯.x % (h)
Refer to Chapter 6: "The MMI - Man Machine Interface" - The MMI Menus (DIAGNOSTICS).
UNFIL. TACH INPUT 58
⎯.x % (h)
Refer to Chapter 6: "The MMI - Man Machine Interface" - The MMI Menus (DIAGNOSTICS).
BACK EMF 60
⎯.x % (h)
Refer to Chapter 6: "The MMI - Man Machine Interface" - The MMI Menus (DIAGNOSTICS).