Parker 591C - System Port (P3

D-120 Programming 590 Series DC Digital Drive
SYSTEM PORT (P3)
Use this block to configure the drive's P3 port.
Refer to Appendix A: “Serial Communications” - System Port P3 for further information.
The P3 port is a non-isolated serial communications port built in to the drive's Control Board.
It is used off-line (while the drive is stopped) for transferring and saving drive configuration files
using a personal computer (PC) running a serial communications program, or on-line (while the
drive is running) when using the Parker SSD Drives 5703 Setpoint Repeater Unit.
You can also use the P3 port to transfer configuration files by connecting to a PC running the
Windows
TM
compatible software package "DSE Lite". Refer to the DSE Lite manual
ha471486U001.
SYSTEM PORT (P3)
Parameter Tag
MODE 130
Used the set the protocol on this port.
0 : DISABLED
1 : 5703 MASTER
2 : 5703 SLAVE
3 : EIASCII
4 : EIBINARY
BAUD RATE 198
Transmission rate. Options available are:
0 : 300
1 : 600
2 : 1200
3 : 2400
4 : 4800
5 : 9600 (default)
6 : 19200
7 : 38400
8 : 57600
9 : 115200 (reserved for future use)
GROUP ID (GID) 329
The Parker SSD Drives protocol group identity address.
UNIT ID (UID) 330
The Parker SSD Drives protocol unit identity address.