590 Series DC Digital Drive The MAN - MACHINE INTERFACE (MMI) 6-21
How to Save, Restore and Copy your Settings
Saving Your Application
NOTE The local setpoint parameter value is not
saved on power-down.
The PARAMETER SAVE menu,
available in both the full and reduced
view levels, is used to save any changes
you make to the MMI settings.
Pressing the
(UP) key, as instructed,
saves all parameter values (with one
exception, see the note below) in non-
volatile memory.
Operatin
In Operating mode you can change parameter values. The Drive can be running or
stopped. Note that some parameters can only be changed when the Drive is stopped. It is
not possible to modify the internal links when the Drive is in Operating mode.
Configuration Mode (CONFIGURE ENABLE = ENABLED)
In the configuration mode you can modify connections between the function blocks in the
drive. You can also change parameter values, as above. The Drive cannot run in this
mode. Out
To Next Page
Loading...
