590 Series DC Digital Drive The MAN - MACHINE INTERFACE (MMI) 6-17
SERIAL LINKS
This menu contains 3 function blocks. These can be found in the SETUP PARAMETERS menu - refer to Appendix D: "Programming".
SERIAL LINKS
• MAIN PORT (P1) refer to Appendix D:"Programming"
• SYSTEM PORT (P3) refer to Appendix D:"Programming"
• PNO CONFIG refer to Appendix D:"Programming"
SYSTEM
This menu contains 2 parameters and 3 function blocks. The function blocks can be found in the SETUP PARAMETERS menu - refer to Appendix D:
"Programming".
SYSTEM
• SOFTWARE this parameter displays the software release of the firmware in the drive.
• CONFIGURE I/O refer to Appendix D: “Programming” – CONFIGURE I/O
• miniLINK refer to Appendix D:"Programming" - miniLINK
To Next Page
Loading...
