PENKO 1020 - Transducers

5.1.2. Menu Settings -System Setup - Indicator Setup - continue-
1020 Indicator
Repeat the process from Calibration second or higher calibration point
for each extra calibration point.
Press the Esc key six times to go back to the main screen.
x 6
Transducers
Calibration without using an actual weight. It is based on the information provided
with new load cells.
When this function is used, calibration with weights is disabled.
It is possible to set up a maximum of load cells. To set up the used load cells
choose Transducer 1, 2, 3 or 4.
Settings in the Transducer menu
The output value will be provided by the suppllier of the load cells.
The zero balance value will be provided by the supplier of the load cells.
48