Pfaff 1571 - Performing a Cold Start

13 - 56
Adjustment
RESET
No VAL
101 II
TE
No
No
600
TE
No
604 RESET
TE
No
13
.11 Carrying out a cold start
● Switch on the machine.
● Press the TE/Speed key twice to select the input mode.
● Select parameter group "600" by pressing the corresponding +/- key.
● Confirm selection by pressing the corresponding +/- key.
● Enter the code number, see Chapter 9.10 Entering/changing the code number.
● Select parameter "604" by pressing the corresponding +/- key.
● Carry out cold start by pressing the corresponding +/- key.
● Switch off the machine.
After a cold start all programmed values are reset to their status at the time of
delivery.
2 x