8 - 13
Installation and commissioning
8.06 Commissioning
● Check the machine, particularly the electrical wiring, for any damage.
● Clean the machine thoroughly and then oil it or fill in oil (see Chapter 12 Care and
maintenance).
● Have a mechanic check whether the motor of the machine can be operated with the
available power supply, and that the motor is correctly connected in the junction box. If
there are any discrepancies the machine must not be operated under any
circumstances.
8.07 Switching the machine on/off
● Switch the machine on or off (see Chapter 7.01 On/off switch).
8.05 Fitting the reel stand
● Fit the reel stand as shown in Fig. 8-12
● Afterwards insert the stand in the hole in
the table top and secure it with the nuts
provided.
Fig. 8 - 12
To Next Page
Loading...
Need help?
General
