13 - 55
Adjustment
8 805 Right of access function group 500 0 – 1 1 1
806 Right of access function group 600 0 – 1 1 1
807 Right of access function group 700 0 – 1 1 1
808 Right of access function group 800 0 – 1 1 1
809 Right of access program creation 0 – 1 1 1
810 Enter access code 0 – 9999 1500 1500
Message Description
Warning 2 Bobbin thread error
Message Description
Error 1: System error
Error 2: Sewing motor
Error 3: Section
Error 4: End of section
Error 5: Pedal activated when machine switched on
Error 6: Communication error with stepping motor processor
Error 7: End of ramp
Error 8: End position of needle drive not found
Error 9: Centre position of needle drive not found
Error 10: Error of stepping motor processor
Error 11: Stepping motor stepping frequency too high
Error 12: Error in sewing start deflection
Error 13: Error in docu-seam system
Error 14: Incorrect program number (larger than 99)
Error 15: Incorrect section number
Error 16: Memory full
Error 17: Incorrect stitch length
Error 19: Interface to external controller
Error 21: Power supply unit overloaded
Error 22: Mains voltage
Error 23: Power supply 24V too high/too low
13.10 Warning messages
13.09 Explanation of the error messages
Parameter
Setting
range
Set value
1574
Description
Set value
1571/1591
Group
To Next Page
Loading...
Need help?
General
