10 - 3
Sewing
Other programmed sewing functions, also see Chapter 7.09.02 Function keys:
Stitch placement function Raised roller presser after thread trimming
on/off on/off
Knee switch function on/off Thread trimming on/off
Backtack suppression Seam section speed on/off
Start backtack on/off Reverse sewing direction on/off
End backtack on/off Program interruption
Raised needle position on/off Programmed stop on/off
Raised roller presser on/off Sensor on/off
Stitch counting on/off
Sewing ensues with pedal functions, see Chapter 7.04 Pedal.
2
1 1 2.5 2.5
PM
10.03 Program interruption
If a seam program sequence is interrupted (e.g. due to thread breakage), the program
interruption function must be selected.
● After the program interruption key has been pressed, the seam program sequence is
interrupted. It is possible to continue sewing manually, in which case the stitch length
values are taken over from the current seam program.
● With the corresponding +/- key it is possible to select the seam section, in which the
seam program is to be continued.
● By pressing the program interruption key again, the program enters the selected seam
section and the programmed sewing is continued.
To Next Page
Loading...
Need help?
General
