Input
11 - 5
11.03 Altering existing seam programs
The following description assumes that a seam program with all the necessary
parameters has already been created.
● Switch on the machine.
● Select the input variant "seam program input/alteration", see Chapter 11.02 Seam pro-
gram input variants.
● Select the desired program number with the corresponding +/- key.
● After confirming the selection by pressing the corresponding +/- key, the first of up to
five input menus appears, in which the parameters of the selected program can be
altered as described below.
Each of the five input menus can be selected individually by pressing the Scroll
key. Only the input menus of activated functions are displayed. To return to the
program selection menu, press the PM key.
● Select the desired seam section by pressing the corresponding +/- key.
● Select the desired value for the stitch length of the roller presser by pressing the
corresponding +/- key.
● Select the desired value for the stitch length of the feed wheel by pressing the
corresponding +/- key.
● Press the Scroll key to select the next input menu.
2
2 2.5 2.5
PM
P
3
PM
To Next Page
Loading...
Need help?
General
