Input
11 - 8
11.04 Deleting seam programs
● Switch on the machine
● Select input mode by pressing TE/Speed key twice.
● Press PM to select the seam program input function.
● Enter the code number, see Chapter 9.10 Entering/changing the code number.
● Select the required program number with the corresponding +/- key.
● Select the input variant "Deleting seam programs" with the Scroll key, see
Chapter 11.02 Seam program input variants.
2.5 2.5
2x
No VAL
101 II
TE
● Confirm the deletion of the program with the corresponding +/- key.
● Conclude the seam program input by pressing the TE/speed key.
DEL
3
PM
P
3
PM