Table of contents
3827_en_B PHOENIX CONTACT 3/138
4.2 Wall-mounted devices (RAD-900-DAIO6) ...........................................................63
4.2.1 Mounting ..............................................................................................63
4.2.2 Wire entry .............................................................................................64
4.2.3 Connecting wires .................................................................................64
4.2.4 Connecting power ...............................................................................65
4.2.5 Connecting the antenna .......................................................................66
5 Configuration and startup..........................................................................................................67
5.1 Default settings of the wireless module................................................................67
5.1.1 Resetting to the default settings ...........................................................67
5.1.2 Firmware update ..................................................................................68
5.2 Operating mode of the wireless module ..............................................................68
5.3 Setting the address of the wireless module via the thumbwheel..........................71
5.4 Configuration via CONFSTICK ............................................................................71
5.5 Copying device settings via memory stick ...........................................................73
5.5.1 Saving parameters from the wireless module to the memory stick .......73
5.5.2 Reading the memory stick ....................................................................74
5.6 Configuration via PSI-CONF software .................................................................74
5.6.1 Extended configuration, individual settings ..........................................75
5.6.2 Data transmission speed of the wireless interface ...............................75
5.6.3 Device settings .....................................................................................77
5.7 Starting up I/O extension modules.......................................................................79
5.7.1 Combinations of extension modules ....................................................79
5.7.2 Setting the address of the extension modules via the thumbwheel ......80
5.7.3 Wireless module in PLC/Modbus RTU dual mode ...............................81
5.8 Starting up the RAD-900-DAIO6..........................................................................82
5.8.1 Setting the address of the RAD-900-DAIO6 via the thumbwheel .........82
5.8.2 RAD-900-DAIO6 in PLC/Modbus RTU dual mode ...............................83
5.9 Startup time of the wireless station ......................................................................84
6 Serial data mode (RAD-900-IFS only).......................................................................................85
6.1 Frame-based data transmission ..........................................................................87
7 PLC/Modbus RTU mode...........................................................................................................89
7.1 Configuration via PSI-CONF software .................................................................90
7.2 Addressing I/O extension modules ......................................................................91
7.3 Watchdog ............................................................................................................91
To Next Page
Loading...
