Pilz PSEN sc M 3 Series User Manual

Operation
Operating Manual PSEN sc M 3.0/5.5 08-17
1005387-EN-05
| 112
4. Display master unit: Confirm / Cancel
Display subscriber unit: CHECK MASTER
Confirm your entry with Confirm
5. Checking the configuration
Display master unit: RES FAILED. Could not copy the configuration successfully. Con-
tinue by selecting the data for the restoring.
Display master unit: RUN TEST MODE
On the display of the master unit, select Enter Test. Test operation starts. Continue
with accept or reject configuration.
6. Accept or reject configuration
Test operation is complete.
Select Validate conf to accept the configuration. The safety laser scanner is ready for
operation again.
Select Reject conf to reject the configuration. Continue by selecting the data for the
restoring.
7. Create new configuration in the PSENscan Configurator
Display master unit: WAITING CONF
Display subscriber unit: CHECK MASTER
Configure the safety laser scanner in the PSENscan Configurator.
11.6 Reset
With the reset function, the safety laser scanner can be set to normal operation when the
safety laser scanner is in an error state, and the error was rectified.
Procedure:
Hold the reset pushbutton down for at least 500s.
11.7 Activate rest condition
Prerequisites
} At least two zone sets are configured.
} No safety or warning zones are configured in the respective zone set.
Procedure:
1. Select the Configure zone sets window.
Select Rest condition = Activated.
2. The display of the safety laser scanner shows for 30 seconds that the rest condition is
started.
Then the display switches to the energy saving mode and the LEDs will go out.

Pilz PSEN sc M 3 Series Specifications

General

Brand	Pilz
Model	PSEN sc M 3 Series
Category	Accessories
Language	English