Pilz PSEN sc M 3 Series - Psenscan Configurator; Basics; Installation; System Requirements

PSENscan Configurator
Operating Manual PSEN sc M 3.0/5.5 08-17
1005387-EN-05
| 83
9 PSENscan Configurator
9.1 Basics
The PSENscan Configurator is a graphic tool
} For configuration of the safety laser scanners of the PSEN sc M 3.0/5.5 08-17 series,
} For incorporation of the safety laser scanner into a network,
} For monitoring the safety laser scanners in the network,
} For creating reports,
} For management of passwords on the safety laser scanner PSEN sc M 3.0/5.5 08-17
series,
The safety laser scanner cannot be configured via the network. The configuration can only
be downloaded via a point-to-point connection.
9.2 Installation
9.2.1 System requirements
Operating system: Windows 7, 10 or XP (32 Bit and 64 Bit)
Processor: Pentium 4, 2 GHz
3GHz recommended
RAM: min. 2 GB
Available hard drive space: approx. 70 MB
Graphics card: Min. 1024 x 768 pixel resolution, 65536 col-
ours
For optimum performance of the system, a
current graphics card with 3D acceleration
should be used, and the 3D acceleration
should be activated.
To view the documentation: Adobe Acrobat Reader, from Version 7.1.0
Interfaces: A free 100Mbps Ethernet interface for data
transfer to the safety laser scanner
Access rights: Network access for PSENscan Configur-
ator, profile Private
9.2.2 Install PSENscan Configurator
Procedure:
1. Download the software PSENscan Configurator from the download area on the Pilz
homepage under http://www.pilz.com/support/downloads/.
2. Double-click on the unpacked file.
The software PSENscan Configurator is installed.
The installer will guide you through the installation.