Overview
Operating Manual PSEN sc M 3.0/5.5 08-17
1005387-EN-05
| 9
2 Overview
2.1 Device features
Safety laser scanners of the PSEN sc M 3.0/5.5 08-17 series constitute electrosensitive
protective equipment (ESPE type: 3) in accordance with EN 61496-3 for workspaces in
which machines, robots, and automated systems might pose a physical danger to their op-
erators.
} Four safety laser scanners can be connected in series (1 master and 3 subscribers)
} Configurations are created with the PSENscan Configurator:
– With teach-in function when creating zones.
– Support for several zone sets for a difference at exactly two points.
} In a series connection with master and subscriber units, devices with different operating
ranges and different detection capabilities can be freely combined
} Detection capability: 30 mm, 40 mm, 50 mm, 70 mm, 150 mm
} Connection
– With 17-pin M12 connector on supply voltage, evaluation device and inputs or
– With 17-pin M12 connector on supply voltage, evaluation device and inputs and 8-pin
M12 connector on inputs
Max. number Connection to
17-pin male connector 8-pin male connector +
17-pin male connector
OSSD pairs 3 3
Configurable inputs 4 8
Configurable outputs 2 2
Configurable inputs/out-
puts
2 2
Zone sets 20 70
} 3 safety zones independent of each other (one OSSD pair per safety zone)
} LED display and display for status information
} Scan angle: 275°
} Infrared laser beams build up a 2-dimensional protected area
} Separation of the protected area in a safety zone and a warning zone
} Enhanced availability by configurable multiple evaluation
} Muting (2 outputs, 2 inputs)
– Muting in one direction
– Muting in two directions
– Dynamic muting
} Override
} Transferable configuration by saving the configuration in an exchangeable memory mod-
ule
To Next Page
Loading...
