5.24
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
4. Install pinion shaft, bearing, and input cover with new
o-ring and torque bolts to specification.
TORQUE
Input Cover Fasteners:
17 ft-lbs (23 Nm)
5. Install the output hub (A) into the gearcase housing.
The output hub should spin freely.
6. Install the other output hub (B) and thrust bearing (C)
into the output cover. Apply a small amount of grease
onto the thrust bearing.
7. Install the armature plate (D) and spacer washer (E)
into the output cover.
NOTE
Be sure backlash plate is in place. A small amount of
grease can be used to help secure backlash plate.
FINAL DRIVE
To Next Page
Loading...
