To modify the script to enable CallForwardUnconditional on SP1 only, change it to:
*72, Call Forward Unconditional SP1, coll(SP1($cfan)),set(SP1($cfa),1)
*67, Block Caller ID Once, set($BCI1,1)
Enables masking of caller ID information once for the next call on any trunk.
*99, Disable Echo Canceller For One Call, set($Noec1,1)
Disables the Echo Canceller for one call on the current PHONE port.
*74(x|xx), Set Speed Dial, coll($Spd[$code])
After user dials *74, the device expects one or two more digits from the user, which represent a speed
dial slot index (1 to 99). The 1- or 2-digit variable part is stored in the variable $code.
The device then plays a prompt tone and proceeds to collect a number from the user according to the
DigitMap. Finally the device stores the collected number in the given speed dial slot. If the slot already
has a number specified, it is overwritten quietly with the new value.
*75(x|xx), Check Speed Dial, say($Spd[$code])
After user dials *75, the device expects one or two more digits from the user, which represent a speed
dial slot index (1 to 99). The 1- or 2-digit variable part is stored in the variable $code.
The device then announces the number stored in the speed dial slot, or says "not available" if the slot
is empty.
For more information on Star Code parameters, see the Star Code Profile Parameter Guide table in
the Parameter Reference Guide.
Program a Star Code
Program star codes for any enabled feature in addition to the default star codes available.
1. In the system web interface, go to Star Codes > Star Code Profile N.
2. In the Default column, clear the check box for a Parameter Name with an empty value column.
3. In the Value column, enter a star code script in the following format: code, name, action1
For example, for Code30, the star code script is *01, Page Group 1 Talk, pg1tx. Using
the star code *01 sends a page to Group 1.
4. Select Submit.
5. Restart your system when you complete your changes.
50
Chapter 7Star Code Features
To Next Page
Loading...
Need help?
General
