2. Under OBiTALK Service Settings, clear the check box in the Default column for Enable.
3. In the Value column, select the check box for Enable.
4. Select Submit.
5. Restart your system when you complete your changes.
Limit OBiTALK Calls
Limit OBiTALK calls to just the OBihai echo server.
A simple way to disable OBiTALK voice calls completely is by setting MaxSessions="0". If you do,
however, you can’t perform an echo test.
1. In the system web interface, go to Voice Services > OBiTALK Service.
2. In the Default column, clear the check box for DigitMap.
3. In the Value column for DigitMap, enter a value of (<ob>222222222 | ob222222222).
You can change or add more OBi numbers to this digit map by following the same pattern.
4. Select Submit.
5. Restart your system when you complete your changes.
PDMS-SP Service Settings
For more information on PDMS-SP service settings parameters, see the PDMS-SP Service Settings
Parameter Guide table in the Parameter Reference Guide.
For more information on PDMS-SP calling features parameters, see the PDMS-SP Calling Features
Parameter Guide table in the Parameter Reference Guide.
For more information on PDMS-SP inbound direct dialing authentication parameters, see the PDMS-
SP Inbound Direct Dialing Authentication Parameter Guide table in the Parameter Reference Guide.
Auto Attendant Service
Learn about the auto attendant features on your Poly ATA device.
Automated Attendant
The device call processing Auto Attendant (AA) invoked by including “aa” in the inbound call routing
rule associated the interface on the device processing an incoming call.
When connecting to the AA in this manner, there are two options at present.
Note: A Poly ATA device supports only one session of AA at a time. Additional calls routed to the AA
while a session is in progress are rejected by the AA as busy.
AA Callback Service
The device offers two methods for the AA to call you back at a number that you picked (or designated
by the admin of the device).
80
Chapter 12Service Providers
To Next Page
Loading...
Need help?
General
