Configuration and Management Interfaces3
Poly offers several methods to configure or provision your phone.
You can configure and manage your Poly ATA device using the following local interfaces:
● Interactive Voice Response System (IVR)
● System web interface
Alternatively, you can choose to configure and manage your Poly ATA device remotely using the
PDMS-SP.
Interactive Voice Response System
You can use the IVR system as an automated attendant that you can ask for device configuration
information, such as the IP address, and it provides a verbal response. You can also use the IVR to
instruct the device to act on the placement or routing of a call to a particular interface.
There are two IVR menus:
● Auto Attendant IVR 1: This menu is referred to as “aa” (or "aa1") for call processing commands.
For more information about the Auto Attendant IVR for Poly ATA call processing, see Call Routing
and Digit Map on page 70.
● Auto Attendant IVR 2: This menu is referred to as “aa2” for local configuration. If changing the
settings requires that you reboot the device, it’s done automatically when you quit the IVR. You
invoke IVR (AA2) by pressing * * * on a phone connected to the Phone port of your ATA
device.
Configure Basic Settings Using the IVR System
Use the IVR system's main menu to configure basic settings or to access additional configuration
menus.
For a list of the IVR System basic settings, see the
Poly OBi Device Technical Reference
, at Poly
Support.
1. From a phone attached to one of the Phone ports of your ATA device, dial *** to access the IVR
system.
2. Enter the single digit number for the configuration menu item that you want to access.
10
Chapter 3Configuration and Management Interfaces
To Next Page
Loading...
Need help?
General
