Network Settings10
WAN (Internet) Settings
For more information on WAN settings parameters, see the WAN Settings Parameter Guide table in
the Parameter Reference Guide section.
OBiWiFi Wireless USB Adapter
OBiWiFi supports the 802.11 b/g/n wireless standards so that an OBiWiFi Wireless Adapter can be
used with the USB port of the devices.
From an IP routing point of view, OBiWiFi is an additional WAN interface. If both WAN interfaces
are connected (Ethernet port and OBiWiFi), the traffic destined to the WAN side routes through the
Ethernet interface only, unless a) the WAN (Ethernet) interface and OBiWiFi are on different subnet
and b) the destination address is on the same subnet as OBiWiFi.
If the device is set to function as a LAN switch rather than a router, OBiWiFi is disabled internally.
WiFi Scan
The WiFi Scan device page offers a familiar user interface to let you scan for and connect to access
points (APs) in the neighborhood.
To connect to one of the available APs, click on the name. If the AP requires authentication but the
device does not have any valid credentials, a page is returned to prompt you to enter a password or
passphrase and press Connect to continue.
If your AP does not show up as a listed device on this page, perhaps its SSID is not broadcast. You
can enter its SSID and security credentials manually by clicking the Add a Network link. The Manage
Networks link takes you back to the WiFi Settings device page. The Scan For Networks link reloads
this page in order to rescan for the APs in the neighborhood.
For more information on Wi-Fi Settings parameters, see the WiFi Settings Parameter Guide table in
the Parameter Reference Guide. section.
Network Settings
57
To Next Page
Loading...
Need help?
General
