Star Code Features7
Star codes are short sequences of digits that users enter where each sequence serves as a
command to the device to perform a certain operation.
Each sequence usually starts with the star key (*) key followed by a 2-digit code (such as *69), hence
the term star code. A typical operation that you can carry out is to set the value of one or more
configuration parameters. The device allows you to issue a star code from the Phone port only; you
issue a star code the same way you dial a number to make a call.
In the device, every star code and its operation are defined with a short star code script parameter.
The set of star codes that can be dialed from the Phone port is collectively referred to as a star code
profile.
The device has two star code profiles available in its configuration, known as Star Code Profile A and
B. Each profile has 30 star code script parameters, known as Code1 to Code30. You can select either
A or B, or None if star codes aren’t to be used.
Set the Star Code Profile
You can select a Star Code Profile (A, B, or None) for interpreting the star codes users enter on the
phone.
Select which star code profile to use with the StarCodeProfile parameter.
1. In the system web interface, go to Physical Interfaces > PHONE
N
Port > Calling Features.
2. In the Default column for the StarCodeProfile parameter, clear the check box.
3. In the Value column for the StarCodeProfile parameter, choose one of the following star
code profiles:
● A
● B
● None (if you aren’t using a star code)
4. Select Submit.
5. Restart your system when you complete your changes.
46
Chapter 7Star Code Features
To Next Page
Loading...
Need help?
General
