EasyManuals Logo

Polycom realpresence group series Administrator's Guide

Polycom realpresence group series
369 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #225 background imageLoading...
Page #225 background image
Settings Description
DNS Servers Displays the DNS servers assigned to the device. You
can specify IPv4 DNS server addresses only when the
IPv4 address is entered manually. When the IPv4
address is obtained automatically, the DNS server
addresses are also obtained automatically.
Server 1: If the RealPresence Touch device does
not automatically obtain a DNS server address, add
a DNS server address here.
Server 2: If the RealPresence Touch device does
not automatically obtain a DNS server address, add
a DNS server address here.
VLAN Specifies the identification of the Virtual LAN. This
setting is available only when 802.1p/Q is enabled. The
value can be any number from 1 to 4094.
LAN Speed Specifies whether to use 10 Mbps, 100 Mbps, or 1000
Mbps for the LAN speed. If the Autonegotiation
setting is enabled, this setting is read-only. To change
the Autonegotiation setting, in the RealPresence
Group Series system web interface, go to Admin
Settings > Network > LAN Properties > LAN
OptionsSelect or clear the Autonegotiation checkbox.
Duplex Mode Choose the Duplex mode that is supported by the
switch, either Full or Half. If the Autonegotiation
setting is enabled, this setting is read-only. To change
the Autonegotiation setting, use the RealPresence
Group Series system web interface, and go to Admin
Settings > Network > LAN Properties > LAN
Options Select or clear the Autonegotiation
checkbox.
Enable EAP/802.1X
(under EAP 802.1X in the system local interface)
Specifies whether EAP/802.1X network access is
enabled. The following authentication protocols are
supported:
EAP-MD5
EAP-PEAPv0 (MSCHAPv2)
EAP-TTLS
EAP-TLS
EAP/802.1X Identity
(under EAP 802.1X in local interface)
Specifies the system's identity used for 802.1X
authentication. This setting is available only when EAP/
802.1X is enabled. The field cannot be blank
EAP/802.1X Password
(under EAP 802.1X in local interface)
Specifies the system's password used for 802.1X
authentication. This setting is required when EAP-MD5,
EAP-PEAPv0, or EAP-TTLS is used.
Setting Up a Polycom RealPresence Touch Device
Polycom, Inc. 223

Table of Contents

Other manuals for Polycom realpresence group series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom realpresence group series and is the answer not in the manual?

Polycom realpresence group series Specifications

General IconGeneral
Video StandardsH.264, H.263, H.264 High Profile
Audio StandardsG.711, G.728
Content SharingPeople+Content
NetworkH.323, SIP
SecurityAES encryption
Video InputHDMI
Video OutputHDMI
Audio InputHDMI
Audio OutputHDMI
Audio FeaturesNoise Reduction, Automatic Gain Control
ConnectivityEthernet
PortsEthernet, HDMI
CompatibilityMicrosoft Lync / Skype for Business, BlueJeans, Zoom

Related product manuals