Setting Description
Allow Access to User Settings Specifies whether users can access the User Settings
screen through the local interface.
Restrict to HTTPS Specifies that you can access the system web interface
only over port 443. Enabling this setting closes access
through port 80 (HTTP).
Web Access Port (HTTP) Specifies the port to use when accessing the system
web interface over HTTP.
If you change the default (port 80), specify port 1025 or
higher and make sure it is not already in use. You must
include the port number with the IP address when you
use the system web interface to access the system.
(This setting is unavailable if Restrict to HTTPS is
enabled.)
Enable Telnet Access Specifies whether you can access the system using
telnet.
API Port Specifies whether to use port 23 or 24 for API access.
If you select port 23, the diagnostics port changes to
port 24.
Enable SSH Access Specifies whether you can access the system using
SSH.
Enable Diagnostics Port Idle Session Timeout Specifies whether to allow the diagnostics port to time
out at the configured time interval or not. You set the
timeout at Idle Session Timeout in Minutes.
Enable API Port Idle Session Timeout Specifies whether to allow the API port to time out at
the configured time interval or not. You set the timeout
at Idle Session Timeout in Minutes.
Enable SNMP Access Specifies whether to allow SNMP access.
Allow Video Display on Web
(local interface only)
Specifies whether you can use the system web
interface to view the room where the system is located,
or video of calls in which the system participates.
Note: This feature activates both near site and far site
video displays in Web Director.
Lock Port after Failed Logins Temporarily locks the login port after a configurable
number of unsuccessful login attempts have been
made.
Enable Whitelist Specifies whether to enable a whitelist.
Idle Session Timeout in Minutes Specifies the number of minutes a session can be idle
before it times out.
Securing the System
Polycom, Inc. 86