Polyend Play+ - Work Step Options

112
Polyend Play+ Manual Rev 2
NOTES
6.6 Work Step Options.
General selection of a sample or synth and selection of the base
parameters creates a work step when no step or track is selected.
Subsequent placement into steps on the grid will populate each step
selected with the same work step settings. This allows a sample or synth
and set of parameters to be pre-selected and then placed multiple times
across a pattern and provide a fast workow. The settings for each
individual step can be changed later if required.
In addition an existing step on the grid can be ‘copied’ to create a work step
by holding the existing active step for >1 Second.
Deselect all steps and tracks to revert back to editing the work step.
Work Step
The selection of sample or synth and it’s
associated parameters will be applied in
full when placing note steps into the grid.
Place
Tap a [Pad] step to place the work
step in a pattern on the grid
Copy
Hold a [Pad] for >1 Sec to copy
the active step to the work step
Remove
Quickly tap a [Pad] on an active step to remove it from the pattern.
When creating a work step, any parameter adjustments made when
the sequencer playback is stopped will be auditioned real-time
Sequencing Patterns
6