Polyend Play+ - Parameter Overview

52
Polyend Play+ Manual Rev 2
4.1 Parameter Overview.
The 15 rotary knobs are used to set the parameter values. Each knob
controls two parameters. These are labelled under the knob. Some
functions change when in MIDI / Synth Mode, indicated in Italic text in the
table below to reect a MIDI or a Synth parameter.
NOTES
Parameter Summary
4
Parameter
Primary /
Secondary
Description
Master Volume Primary Controls the master volume level for the audio output.
Limiter Secondary Dynamic processor to control volume levels
Tempo Primary Global tempo. Also sets track speed.
Swing Secondary Generates a natural shufe to a track.
Track Length Primary Adjusts number of steps in the track up to 64
Play Mode Secondary Determines the order of the track steps
Note Primary Tunes the sample note in semitone steps
Microtune Secondary Tunes sample pitch in cents
Volume Primary Adjusts the sample volume level / Velocity
Panning Secondary Adjust the sample panorama position L-R / Pitch Bend
Filter Cutoff Primary Adjusts the Filter Cutoff Frequency / CC or Macro
Resonance Secondary Adjust the Filter Resonance amount / CC or Macro
Sample Primary Selects a sample from the folder / Port Chan or Synth
Folder Secondary Sample folder from where to choose / PC or Patch
Sample Start Primary Start of sample play with respect to length / Chord
Sample End Secondary End position of sample play with respect to length
Sample Attack Primary Envelope attack, % of sample fade in / CC or Macro
Sample Decay Secondary Envelope decay, % of sample fade out / CC or Macro
Reverb Send Primary Audio amount sent to the reverb effect / CC
Delay Send Secondary Audio amount sent to the delay effect / CC
Overdrive Primary Overdrive amount applied to the sample / CC or Macro
Bit Depth Secondary Bit depth setting / CC or Macro
Repeat Type Primary Sets the number of repeats on the step
Repeat Grid Secondary Sets the density for the repeats set on the step
Chance Primary Determines the probability of an action occurring
Action Secondary Sets the action to occur after a step trigger
Randomize Primary Strength of randomization applied.
Randomize Type Secondary Determines what is affected by the randomization
Move Primary Moves steps across the grid in 1 step intervals
Micromove Secondary Moves steps across the grid in micro intervals