114
Polyend Play+ Manual Rev 2
NOTES
6.7 Select & Adjust Step Editing.
Steps individually or as a collective group that have already been placed
into a pattern can be edited individually. Tracks can be selected which also
allows the entire track to be edited where existing note step parameters are
adjusted relative to their original value. Tracks and groups of steps can also
be copied between Audio Sample and MIDI / Synth Tracks.
▌ SELECTING BLOCKS OF MULTIPLE STEPS
1. Steps can be selected and held individually or collectively as a track.
Also multiple steps across tracks can be selected as a block where a
rectangular selection zone is used to select all steps contained within.
2. Ensure sequencing mode is selected. If pattern mode or perform mode
is selected, Press [Patterns] or [Perform] respectively to toggle back to
Sequencer mode. This is the grid view which allows an individual
pattern to be sequenced.
3. Hold [Shift] + [Pad] ‘A’ for the rst pad. Pad A is the rst corner of the
selection rectangle. Keep [Shift] + [Pad] held.
4. Press [Pad] ‘B’ for the second pad. This is while still holding [Shift] +
[Pad] ‘A’. Pad B is the second, diagonally opposite corner of the
selection rectangle. The rectangular selection will be applied with blue
pads and all note steps lit bright blue, within the block are selected for
editing.
5. To remove or add the selection of individual steps within the block, Hold
[Shift] and Tap [Pad] for the pad to remove from the rectangular
selection block or to add to the block. Also applies when selecting
tracks. This removes / adds only the selection and does not delete
actual note steps.
6. To remove a selection, Tap [Shift]. The individual or multiple selection,
not actual note steps, is removed. When no selection is active, the state
reverts back to work step editing. If required, use [Shift] + [Fill] to Delete
any note content within a selected area.
7. Parameter changes will apply to all steps selected. A tilde ‘~’ symbol is
displayed for a parameter where multiple values exist in the selection
and adjustments will then show +/- as a offset from each individual step
setting for the parameter.
8. To reset a selected parameter to its default, Double Tap [Screen] upper
or lower left screen button for the parameter to reset.
Sequencing Patterns
6
To Next Page
Loading...
