Polyend Play+ - Editing a Synthesizer Patch

88
Polyend Play+ Manual Rev 2
NOTES
5.9 Editing a Synthesizer Patch.
A patch can be initialised as a blank starting point and edited to create new
sounds. These can then be saved to the SD card. Each synth model has a
number of parameters specic to the engine loaded. The patch editor is
where patch settings can be adjusted.
▌ EDITING A PATCH
1. Ensure the project in which to work is open and active.
2. Press (Screen) to select the options menu.
3. Turn (Screen) to highlight and Press to select ‘Synths’ options.
4. Each of the available 3 synths can have one of the 4 synth models
assigned. This will determine its audio style and format. Turn (Screen)
to highlight and press to select one of the Synths.
5. Either initialise the patch or load the patch to edit.
6. To edit the currently selected patch. Turn (Screen) to highlight ‘Edit
Patch’. Press (Screen) to open the patch editor and access the settings
for the patch parameters.
7. Turn (Screen) to scroll and highlight the parameter for editing.
8. Turn (Tempo) to adjust the parameter value for the highlighted option
while in the list.
9. To select the parameter individually for editing, Press (Screen) knob or
one of the left side [Screen] buttons and then turn (Screen) to adjust the
parameter value.
10. The view keyboard can be used to preview the patch as it is being
edited. To select the view mode press [View].
Samples & Synths
5