80
Polyend Play+ Manual Rev 2
NOTES
5.5 Sample Selection Overview.
Play+ workow for using samples starts with a ‘pick and place’ process.
The rst step is therefore to pick a sample to be placed onto the grid in
order to create patterns. The sample has a number of parameters that can
be edited. The sample selected and any other parameter settings are held
in the buffer memory which then allows continuous and repeated placement
in the sequencer. When sequencer steps and tracks are deselected, the
sample and other parameter settings edited together collectively, ready for
step placement are called the ‘work step’.
▌ SELECTING A SAMPLE TO EDIT OR PLACE IN THE SEQUENCER
1. Ensure the project in which to work is open and active and the sample
pool is populated with samples.
2. Ensure no steps or tracks are selected.
3. Double tap (Folder) to select the Folder parameter in the sample / folder
screen. This allows selection of the sample folder from which to select a
sample. Turn (Folder) to select the sample pool folder. Only folders
which contain samples will be visible.
4. Tap (Sample) to select the sample parameter. Also Press left upper or
lower [Screen] buttons to switch selection between the sample and
folder parameter option.
5. Turn (Sample) to navigate the sample selection. Also Turning (Screen)
will adjust the in focus parameter currently selected on the screen.
Samples are auditioned while browsing when the sequencer is stopped.
6. Once a sample is selected, a number of sample related parameters can
be edited. The sample is auditioned as edits are made as long as the
sequencer is stopped and not playing.
7. The sample can be placed into a pattern by tapping a grid pad.
Samples & Synths
5
To Next Page
Loading...
