Polyend Play+ - Page 91

91
Polyend Play+ Manual Rev 2
NOTES
Samples & Synths
5
Function Parameter Range Description
Oscillator Fatness 0-100 Oscillator style
Oscillator Brightness 0-100 Oscillator style
Oscillator Timbre 0-100 Oscillator style
Oscillator LFO Amt 0-100% Amount of LFO applied
Oscillator Noise 0-100% Amount of Noise applied
Oscillator Reset Options
On or Off. On, resets oscillator cycle on
each note trigger.
Filter Cutoff 20Hz - 20kHz Filter cutoff frequency
Filter Resonance 0-100% Filter resonance amount.
Filter Type Options
Low Pass MG 24dB, Low Pass OB 24dB,
Low Pass OB 12dB classic lter emulations.
Filter Env Amt -100% to 100% Filter envelope amount
Filter LFO Amt -100% to 100%
Low Frequency Oscillator modulation
amount applied to the lter
Amplier Env Attack 0.00-10 Sec Amplier envelope attack time
Amplier Env Decay 0.00-10 Sec Amplier envelope decay time
Amplier Env Sustain 0.00-100% Amplier envelope sustain level
Amplier Env Release 0.00-10 Sec Amplier envelope release time
Filter Env Attack 0.00-10 Sec Filter envelope attack time
Filter Env Decay 0.00-10 Sec Filter envelope decay time
Filter Env Sustain 0.00-100% Filter envelope sustain level
Filter Env Release 0.00-10 Sec Filter envelope release time
LFO Frequency 0.1 to 100Hz Speed of the modulation wave
LFO Waveform Options
Modulation waveshape: Triangle; Sin; Ramp
Up; Ramp Down; Square; Random S&H
LFO Retrigger Options
Waveform retrigger: Free running will
continuously run; One Shot will cycle once
when a note is triggered; Note will trigger
from the start and continuously run each
time a note is triggered.