Preproofer 770 - Run the Test Program

Setup Electronic Box – HW Revision 1 – OLD STYLE
Setup the Lantronix Device
13
Preproofer x700 / x900 – HW Installation Manual 13-11
PP x700/x900 v1.7
13.2 Setup the Lantronix Device
To connect from the computer to the Electronic Box,
you need to install and configure the Lantronix
Device (built in Ethernet to Serial converter).
See the document “Quick Start SW for Preproofer
LONGSTREET x700 x900 english.pdf”, chapter
“Install the software for the Electronic box”
13.3 Run the Test Program
Install the DI-Pilot software which is available on the
delivered Preproofer CD.
The latest installer is always available on
the web site www.digiinfo.com
Run the program „ElectronicBox test program”
which is found under Start, Programs, Digital
Information Ltd, DI-Pilot, Utility