Preproofer 770 - Setup Motor Speed

Setup Electronic Box – HW Revision 2 – Nov 2011
Calibrate the CUT Motor Parameter
12
Preproofer x700 / x900 – HW Installation Manual 12-9
PP x700/x900 v1.7
Step 8
Test the cutter:
Change to the tab “Test”. Press the button “CUT –
Printer BOTTOM”.
The Epson printer runs a cut process.
12.5.2 Setup Motor Speed
Change to the tab “Service” and open parameter
“Motor speed value”.
9x00 Printer:
Set the parameter to 225.
7x00 Printer:
Set the parameter to 225.