ProntoNetLC User Manual
20
SEARCH Searching for synchronisation. The displays shows the word
“SEARCH”:
The Decoder status information only appears if the line is connected.
If the line is showing an IDLE status, an indicator code will show the cause of the
last disconnection below. In Appendix B you will find explanations for each of these
codes.
When the lines are connected the direction of the arrow will indicate if the unit made
or received the connection.
When ProntoNetLC is configured to DOUBLE mode over IP, there will be
two lines and the unit will work as a DUAL codec, that is, two independent
communications. To access the information about line 2, the user has to press
the right and left arrow keys on the front panel. An arrow on the right or on the
left side of the screen will inform the user about this situation.
If the user presses the right arrow key on the front panel, the display will show
the information related to the second line.
If the user presses the left arrow key on the front panel, the display will show
the information related to the first line again.
L 2 : N O T A V A I L A B L E
C O N N E C T E D F R A M E D
L 2 : N O T A V A I L A B L E
To Next Page
Loading...
