Making UPS Settings
These settings control how the Vess R3600 subsystem detects the UPS unit and responds to data reported by
the UPS unit.
To make UPS settings:
1. Click the Device tab.
2. Click the UPS icon.
3. Click the UPS Settings button.
4. Perform the following actions as required:
• Choose a Detection Setting from the drop-down menu:
* Auto – Default. If a UPS is detected when the subsystem boots, the setting
changes to Enable.
* Enable – Monitors UPS. Reports warnings and logs events.
* Disable – Does not monitor UPS.
• Type values into the Threshold elds:
* Running Time Remaining Threshold – Actual time below this value resets
adaptive writeback cache to writethrough. Default is 5 minutes, range is 3-20
minutes.
• For UPS units with network cards, type the IP addresses or
DNS names in elds UPS 1 and UPS 2. See Note 2.
5. Press Submit to save your settings.
Note 1: Vess R3600 supports multiple UPS units using network or USB connections, but not a
combination of both methods.
Note 2: To specify UPS units by DNS names, ask your IT administrator to add the DNS names to
the DNS server, before you make UPS settings. DNS settings must rst be congured in Network
Management using the Global Settings menu.
109
Promise Technology
Management with WebPAM PROe
To Next Page
Loading...
Need help?
General
