2.2.1 MULTIPLE DEVICES IN ALARM
In the event of more than one device producing a fire condition, the display will show the following :-
Pressing the → key will scroll the display to show the description of each device in an alarm condition.
2.2.2 GENERAL ALARM
The 6400 system is also used to display General Alarms. If the system is a General Alarm one then the ‘ALARM’ led
and the zone led will illuminate but if the system is a Fire Alarm one then these two leds will not illuminate to prevent
confusion with a fire signal. The display of a general alarm is shown below :-
Displays the Node /
Loop / address and type
of the device in alarm
Note - If text has been
assigned to the node,
then the text will be
displayed rather than the
node & loop No
Displays the ‘Zone’
number in which the fire
has occurred
Displays the date &
time of the activation
Displays the number of
fault events currently on
the system
Displays the number of
disablements currently
on the system
Displays the number
of Devices which are
currently in an alarm
condition
General Alarm
Displays the Node /
Loop / address and type
of the device in alarm
Note - If text has been
assigned to the node,
then the text will be
displayed rather than
the node & loop No
To Next Page
Loading...
