Protec 4400 - Clear System Fault

93-310-10 Issue 4 Rev 5 Page 63 of 88 Copyright Protec Fire Detection PLC
6400 OPERATING MANUAL
C
C
L
L
E
E
A
A
R
R
S
S
Y
Y
S
S
T
T
E
E
M
M
F
F
A
A
U
U
L
L
T
T
11.1 CLEAR SYSTEM FAULT
Each DCN on the network has a ‘SYSTEM FAULT’ warning lamp. This fault is latching, and will occur after a
complete system failure either due to a prolonged or full power down of the panels microprocessor.
Selecting option ‘7’ ‘Clear system fault’ from the ‘Main menu’ options, will extinguish the ‘SYSTEM FAULT’ LED
on all nodes.