4-17
VIBXPERT II 05.2012
Configuring the result display (Display Setup)
In the Results display, after a measurement:
• PresstheMENUkeyandclickon'DisplaySetup'.
In the selection field of the measurement tasks (Multimode):
• Highlightthemeasurementtasksymbol.
• PresstheMENUkeyandhighlightthe'DisplaySetup'entry.
• Pressthenavigationkeyrightandclickon'Measurement'or'Trend'
respectively (s. below).
X. Continuous measurement (‘live mode’)
In‘Livemode’,youcancheckthesignalqualitybeforebeginningwith
datacollection(seep.3-4).
A1. Display Setup for measurement: Overall values
display limit as...: The limit values can be displayed as an absolute
value or as a difference ('Delta value') to the measurement value.
display overall peak value: Selectthecharacteristicvibrationvaluethat
istobedisplayedbydefaultwiththe'RMSvalue'.Afterthemea-
surement, press the navigation key up repeatedly to display the
overall values of the series that were not displayed. If the thresh-
oldvalueisexceeded,theRMSvaluesandtheoverallvaluethat
exceeded the threshold value by the largest amount are displayed.
A2. Display-Setup for Trend: Overall values
meas. value:Selectionofoverall values. The line type can be selected
and the labeling can be shown for each trend curve.
show...: Limits, event markers, references and the associated labeling
can be displayed in the chart. The line type can be selected.
Zoom:Speedorstepsizewhenzooming
layout: The values on the trend curve can be identified with markers.
A grid can be displayed for easier evaluation of the data and the
cursor can be displayed as a cross (short) or line cursor (long).
Left:
Opening the Display Setup
before a multimode measurement
Right:
Display Setup for Overall Trend
Display setup
Display Setup
for overall values with more than two
quantities.