PRÜFTECHNIK VIBXPERT II - Display Settings, Switchoff and Additional Options

2-13
VIBXPERT II 05.2012
Display settings, switchoff and additional options
• Clickon'Display'inthe'DeviceSetup'screen.
Brightness: Press the navigation key right or left until the desired
brightness is achieved. To accept the setting, press 'Enter'.
switch Backlight off / auto power off: The display/ the device auto-
matically switches off if no action occurs within the turn-off time
(illumination:10s...1m/device:6m...6h).Toswitchonthe
display, press any key. The automatic switch off is disabled in the
measurement screen / results screen.
show Battery charge: Display the residual battery charge in percent.
spectrum: show lines Below lower frequency (f
min
): In spectra with a
lower limit frequency of f
min.
>0Hz,thelinesbetween0Hzandf
min.
are displayed in the diagram if this option is enabled.
hide caliBration hint: The message for overdue calibration is not
shown.
• Toacceptthesettings,pressMENUandclickon'OK'.
Protective display film
To protect the display against damage, it is covered with a scratch-
proof transparent film. The film is easy to remove.
Getting started - Basic settings

Note
Display settings