PRÜFTECHNIK VIBXPERT II - Connecting the VIBXPERT to the Multiplexer

3-42
VIBXPERT II 05.2012
S2 S4 S6 S8
S1 S3 S5 S7 S9
VIBBUS - MUX 3494
NEXT MUX
STRING LINE
S2 S4 S6 S8
S1 S3 S5 S7 S9
VIBBUS - MUX 3494
NEXT MUX
STRING LINE
Connecting the VIBXPERT to the multiplexer
InstalltheBNCconnectingadapter(VIB5.346-MUX)onthe1stmul-
tiplexer in the string line as follows:
• Open the cover of the multiplexer.
Do not touch strip conductors and components on the PCB! Electro-
static charges can damage or destroy them. Preferably you should
useanESDwriststrap.
• Loosenthescrewedcableglandattheinput(Stringline)andin-
sert the BNC connecting adapter into the multiplexer as far as it
will go.
• ConnecttheopenendoftheBNCconnectingadaptertothe‘MAS-
TERline’ terminal.
• Tighten the screwed cable gland on the multiplexer and close the
cover.
• Connect the VIBXPERT to the multiplexer, using the connecting
cable(VIB5.346).
• After the measurement, attach the protective cap to the BNC jack.
Cable gland, M20

Note
VIB 5.346-MUX
1. Multiplexer
BNC adapter
(VIB 5.346-MUX) installed
Protective cap
Clamping range cable gland
Multiplexer
S2
S1
- MUX 3494
STRING LINE
MASTER- line