PRÜFTECHNIK VIBXPERT II - Changing the Sensor; Entering the RPM Manually

3-18
VIBXPERT II 05.2012
Options
Changing the measurement channel
Route/machine template:
• Inthetree/listview,presstheMENUkeyandclickon‘Runtime
Setup:Route’(seebelow).
• Selectthemeasurementchannel(A,B,Auto=thechannelsetin
OMNITREND). ‘Auto’ is required when the route uses the ‘Near
location’ or ‘Triax sensor’ function.
Changing the sensor
Multimode:
• Highlightthemeasurementtypeintheselectionscreen.
• PresstheMENUkey,andclickon'Taskmanager'.
• Inthe'SensorSetup'eldclickinthepulldownmenuandselect
therequiredsensor(P.3-17).
• Tosavethechange,presstheMENUkeyandclickon'OK'.
Route/machine template:
• Inthetree/listview,presstheMENUkeyandclickon‘Runtime
Setup:Route’(seebelow).
• Activatethe‘Usedefaultsensor’option.
• Selectthesensorthatistobeusedforallvibrationmeasurements
on the route/in the machine template.
Do not activate when the route uses the ‘Near location’ or ‘Triax
sensor’ function!
A standard sensor can be set up for all routes in the 'Route' device
setup.(p.2-17).
Entering the RPM manually
• Route/machinetemplate:
- In the tree/list view, press the MENU button and click on ‘Runtime
Setup:Route’(seebelow).
- Activate the ‘Manual RPM input’ option.
Left:
Select Runtime Setup
(Route)
Right:
Change measurement channel
(Route)

Note