PRÜFTECHNIK VIBXPERT II - Route

2-14
VIBXPERT II 05.2012
Getting started - Basic settings
Left:
Basic settings for the route/
template operating mode
Right:
Setting up the display
Route
• Clickon'Route'inthe'DeviceSetup'.
ThesettingsintheRouteSetupapplytomeasurementsinthe'Route'
/'Template'mode.TheRouteSetupcanbecalledupandadjustedat
any time in the route/template. For clarity, the numerous settings in
theRouteSetuparegroupedintothreesubmenus(seebelow):
Route display settings
• Clickon'Display'tosetupthefollowingoptions:
Route display type
The route/machine template can be displayed in the hierarchical tree
view or as a list.
-
tree: In this view, the measurement locations and the higher-level
hierarchies are displayed as a tree structure, as they are in OMNI-
TREND. The measurement locations are processed in the defined
order.
-
list: The list view shows the measurement locations in the order in
which they are processed.
If the machine templates were created in the 'Production test'
mode, a list view is not possible.
Graphic Route
Graphicuserguidanceusingmachinegraphicsthatindicatetheposi-
tion of the measurement locations and the measurement direction.
This display mode is only possible when the route is displayed in the
tree view.

Note